Axleback Exhaust - 2013-2017 Crosstrek XV - Dual Chamber with 5" Muffler - Single Exit - 3" Double Wall Tip

The wait is over - our dual chamber no drone exhaust system is available now, tuned specifically for the FB20 engine in the 2013-2017 Subaru Crosstrek XV.  And what's more, it's now available in our single exit series, featuring a 3" Double Wall stainless exhaust tip, clearance for most market leading trailer hitches, and an upgraded mounting solution including a three hole urethane exhaust hanger bushing.  

Ever wish you could have an exhaust that was quiet when you want quiet yet aggressive when you want aggressive? Wish no more! Our new Dual Chamber no drone exhaust system is here!

This system offers the same crisp exhaust notes that our 5" muffled systems on the outside of the vehicle, while reducing cabin noise in the low RPM ranges. literally the best of both worlds - ultra mild at cruise, and an appropriate growl inside and outside when you feel like doing some "spirited driving". 

Featuring both a 5" conventional "zero-restriction muffler" and a frequency tuned "helmholtz" resonator. Want to know more about the science behind this design?  Check out our our blog article, "Calculating The Perfect Exhaust Note." Don't care about the science and just want the results? Visit our YouTube page or click the video below to hear how it sounds!

 "New helmholtz exhaust designed by @namelessperformance received and installed. Impressive build, quality, and sound... and most importantly for my wife, absolutely no drone in the cabin. Nameless hit a home run with this one. Thank you!" was what our first customer had to say about this after driving the 5" muffler and wanting to have less cabin noise.  

Featuring factory fit laser cut flanges and 2.25" piping that provides excellent breathing characteristics for high end horsepower and torque while retaining the appropriate frequency to reduce in-cabin drone and keeping excellent sound outside the car.

Fits 2013-2017 Subaru Crosstrek XV with OEM or OEM fitment midpipe. Will not fit the newer models.

Each axle back exhaust system comes with a full hardware kit and gasket for a simple and clean installation.

Recommended Add-Ons:

Exhaust Hanger Bushings

Upgrading to our long lasting Nameless Performance urethane exhaust bushings from the factory rubber bushings is highly recommended. The softer rubber factory bushings are overly flexible and if you race your car or spend time at an incline off-road, the exhaust can "wag" left to right which sometimes causes noise or the tips to touch the rear bumper on Crosstrek and Impreza applications. When this happens there is a chance your bumper can be damage or if you have a hitch or any other accessories can cause annoying sounds. The best way to avoid this is to use our urethane exhaust bushings to hold the exhaust in place. These upgraded bushings are not necessary to install our exhaust systems but for the small cost of upgraded units, it is an excellent idea!

• Add 3 Bushings to your cart: Replace 3 rubber bushings on the axleback portion of the exhaust.
• Add 4 Bushings to your cart: Replace 3 rubber bushings on the axleback portion of the exhaust as well as the single bushing on the midpipe.

Exhaust Hanger Bushing Removal Tool

This tool makes removing the hanger bushings a breeze. We highly recommend this tool, it turns the removal process from frustrating to satisfying.

• Easily remove hanger bushings
• High Quality Steel Construction

Add an Exhaust Hanger Bushing Removal Tool to your cart (US Shipping)
Add an Exhaust Hanger Bushing Removal Tool to your cart (International Shipping)